Xante ScreenWriter 3, Manual

Page: 155 / 288

_______________________________________ Ethernet Setup 5-17
Note: If no password is required to access the Novell server,
this step is not required.
a. Choose Controller: Novell: Set Print Server Password.
b. Type in the password exactly as it was entered on the file
server. The password must follow Novell NetWare
naming conventions, and lower-case letters will be
converted to upper-case.
Note: The printer enters a waiting state while it saves
the file server name. Do not proceed until the
printer displays the
READY/IDLE
message.
6. Repeat steps 2 through 5 to add up to four file servers.
7. Print a start-up page by taking the printer off line, pressing the
front panel Test button, and then putting the printer back on
line. Check the page to be sure the new print server name is
enabled.
8. Go to “Configure the Novell Print Server Interface” later in this
chapter to continue configuration. To complete the configuration
using the printer’s front panel menus rather than XANTÉ
Command Center, choose File: Exit to close Command Center.
Using XANTÉ Command Center (Macintosh)
1. Open XANTÉ Command Center by double-clicking its icon.
2. Choose Networking: Novell Print Server: File Servers. Click
Add New to open the new file server window.
Fig. 5.15 New File Server Window