Xante ScreenWriter 3, Manual

Page: 190 / 288

6-18 Configuration bb ______________________________________
Set Idiom Recognition using the MISC:IDIOMREC configuration
menu. Yes, the factory default, enables this feature; No disables it.
Initial Job
Initial Job allows you to direct the printer to execute a Sys/Start file
from an optional hard disk each time the printer is turned on.
Set Initial Job from the MISC:INITIAL JOB configuration menu.
Yes, the factory default, directs the printer to look for a Sys/Start file
during printer initialization. No disables this feature.
Interface Control
Your printer features three standard simultaneously active interfaces.
The LocalTalk port, the serial (RS232) port, and the parallel port
allow you to send files from Macintosh and PC computers
concurrently. The optional Ethernet port supports EtherTalk, Novell
Print Server, NetBEUI, and TCP/IP (LPR). See chapter 5 about
configuring the Ethernet interface for your network environment.
Use the Interface (I/F) configuration menus to set printer interface options.
ENTER
I/F:IP ADDRESS
192.009.200.201*
*Default address
I/F:NVL PSRV
ENTER
ENTER
ENTER
I/F:RS232
ENTER
I/F: XXXX*
RS232:ENABLE
RS232:MODE
RS232:BAUD RATE
RS232:PARITY
RS232:FLW CNTL
RS232:DATA BITS
RS232:STOP BITS
RS232:SPOOL
I/F:PARALLEL
PARALLEL:ENABLE
PARALLEL:HNDSHK
PARALLEL:MODE
PARALLEL:SPOOL
XXXX*:ENABLE
XXXX*:MODE
XXXX*:SPOOL
NVL PSRV:ENABLE
NVL PSRV:MODE
NVL PSRV:PRTOCOL
NVL PSRV:SPOOL
NVL PSRV:TIMEOUT
TEST MENU
ENTER
SETUP:I/F
* XXXX will be replaced
by the selected interface
(LTALK, ETALK, LPR,
or NETBEUI
Fig. 6.10 Interface Menus