End Point
Interface path: WFLY → [General Menu] → [End Point]
This function can adjust the end point on the left and right sides of the servo respectively, for correction
on the machine body connection.
The end point on the left and right sides can be 30%-155% (CH1-CH12), and the default value is 100%.
The maximum end point limit can be set between 0% and 155% with a default value of 135%.
After setting this limit point, even if the operation such as mixing control increases the steering stroke
amount, the action of the servo will not exceed the limit point, thus locking the servo and protecting the
connection.
The actual rotation of each channel servo is displayed on the interface. The display of the neutral
position is based on the setting value of “Sub Trim”. Therefore, the adjustment of “Sub Trim” will affect the
upper and lower limit points of the servo position.
1/3
Aileron
Elevator
Throttle
Rudder
Gyro
Limit
135
%
135
%
90
%
135
%
135
%
Travel
100
%
100
%
100
%
100
%
100
%
Travel
100
%
100
%
100
%
100
%
100
%
Limit
135
%
135
%
135
%
135
%
135
%
1
2
3
4
5
End Point
Direction
Left limit
Left
travel
Right
travel
Right limit
100
%
travel
90% limit
,
100
%
travel
155
%
limit
0
%
center
155
%
limit
Example of operation (upper right picture
shows maximum limit and default travel):
1 As shown in the chart above, the left limit of the
throttle has been set to 90%. The throttle stick we hit
the maximum position, as shown below. Although
the stroke is still 100%, the maximum limit (red line
position) output is limited to 90%.
2 The left limit of the throttle is still 90%, and the
stroke is changed to 50%. The throttle stick we hit
the maximum position, as shown below. Although
the limit is 90%, the throttle's output travel is limited
to 50%, so the output maximum position can only
reach half of the normal travel (red line mark).
100
%
travel
155
%
limit
0
%
center
155
%
limit
90%
,
50
%
limit
travel
100
%
travel
100
%
travel
155
%
limit
0
%
center
155
%
limit
059
General Menu
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...