Wfly ET Series, Instruction Manual

Page: 99 / 131

Motor 2/2
Speed1
Speed1
→
2
Speed2
In Out
0
0
0
0 0
Motor
Motor
Status
Switch
Stop position
INH
- -
0
1/2
Once time
Status
Speed
INH
INH
Function status button (INH, ON, default [INH])
Function control switch (default [--])
Motor off position, click to get parameters
Speed control switch, default [INH]
Operation mode switch, default INH]
Throttle output position
Current position of the stick
Interface path: WFLY → [Model Menu] → [Motor]
This function allows you to set the speed of the motor after the motor has been activated by a switch.
Two ranges of operating speeds, slow flight and high speed flight (speed 1 / speed 2) can be set. This
function can also be operated as a safety function by programming to a control switch.
Speed 1and Speed2 reaction
Demarcation line offset, range ±100
Adjust the speed below the
current throttle bar
Adjust the speed above the
current throttle bar
●
Set the motor control switch in [Function].
● The input/output motion speed can be adjusted separately in both ranges (speed 1 / speed 2).
● The boundary points of the two ranges can be moved (speed 1 → 2).
● It can be set when the motion speed is set to only the first "input" direction operation. However, if the
switch is turned off before the action is completed, it will still be valid for the next operation. To set this
action again, simply set the “Speed” status switch and the “One Time Mode” switch to [INH] in the speed
setting interface, and then set it to [Enable].
● When setting or changing the control switch, you need to set or change it in the function setting
[Function] page of the context menu. (Set in the control switch corresponding to [Motor].)
* Flight conditions: Set the "Flight Conditions" control switch in [Model Menu] → [Condition] to switch
through the switches and perform function settings separately.
Notice:
● First determine the direction in which the motor is turned off, then set the speed. If you need to modify
the direction of the closing, the servo speed must also be reset.
● It is recommended to set it with the [Fail Safel ] function.
● The basic movement direction should be set with the ESC. Reverse function can be used.
● Be sure to set the position where the motor is turned off (stop position).
* The speed here refers to the acceleration and deceleration speed (reaction speed) of the motor
homing
The direction corresponding
to the right throttle state
Speed indication
099
Model Menu\Airplane