Wfly ET Series, Instruction Manual

Page: 26 / 131

System Setting
Trainer
Aileron 1
2 Elevator
ON
ON
1
/2 Trainer
Trainer Mode
Teach SW
CHmode 12CH
CH Status
- -
Interface Path: WFLY → [System Setting] → [Trainer]
Trainers can assist students in learning flight skills and improving flight levels based on their flight
experience and operational level. A special trainer line (sold separately) is required between the trainer
and the trainer to connect. The trainer must turn on the trainer mode before the trainer can be operated.
When the trainer switch is turned off, it will return to the trainer transmitter to control the flight. When the
student machine flight is dangerous or the deviation is too large,the trainer can be switched immediately to
ensure safety.
When using the WFT08/09 as a trainer, please purchase a universal analog patch cord, 3.5mm male to
male audio cable. (The coaching line and audio cable need to be purchased separately. Two cores and
three cores are available.)
Be sure to check that all channels of the
trainer and the student can be operated
normally before flying. Be sure to insert
the interface of the trainer line to avoid
loosening.
NOTICE
Mode: Normal, Trainer, Simulator, Student
- Normal: Default mode (non-"Trainer", "Student" mode
using trainer function may cause malfunctions! )
- Trainer: Control transmitter;
- Simulator: When the flight is practiced through the
computer-side simulator, the RF is turned off, reducing
power consumption.To extend the working hours of the
transmitter;
-Students: Turn off RF transmission,only the trainer turn on
theTeach switch can trainer channel could be controlled!
(Example: The trainer model has only three channels:
aileron, direction and gyro, so the student can only control
these three channels when the coach turn on the trainer
switch. )
Channel Mode: default is "12 channel" setting; "8 channel
mode" is compatible with WFLY training function of the
"WFT" series products. The trainer’s two ET12s need to be
set up to the same mode.
Trainer Switch: Default [--]
Status: Each channel status switch of trainer. Turn on,
students can be controlled; off, students Uncontrollable
Trainer Setting:
Trainer switch → Trainer, channel mode → 12
channels, channel status → Turn on with demand
(status is the same as the student machine).
* The channel defaults to full on, and the visual
model and actual application are adjusted.
Student Setting:
Trainer switch → student, channel mode → 12
channels, channel status → Turn on with demand
(status is the same as the trainer).
* The channel defaults to full on, and the visual
model and actual application are adjusted.
*The following trainer functions take the same model as an example.
026