Wfly ET Series, Instruction Manual

Page: 56 / 131

Function
Function
5
4
3
2
1
Aileron
Elevator
Throttle
Rudder
Gyro
Contrl Trim
J1 T1
J3 T3
J2 T2
J4 T4
- - - -
1/3
Interface path: WFLY → [General Menu] → [Function]
When selecting the model and wing type, the servo output channel and function combination has been
preset. If necessary, you can change the servo output.
The combination of the road, functions (ailerons, elevators, etc.), control (stick JI-J4, switch SA-SH,
trimming T1-T6, lever) and corresponding trimming can be customized.
Channel: When channel switching is used, the current channel will be replaced, and the replaced
channel will automatically change the setting data (stroke adjustment, neutral point trimming, servo
reverse, fail safe, etc.). (You can specify the same function to different servo output channels, such as
assigning elevators
Go to channel 2 [CH2] and channel 3 [CH3]. )
Control
switch
select
Negative value display,
positive or midpoint hidden
Positive value display,
negative or midpoint hidden
Output channel
Example operation for assigning elevators to channel 2 [CH2] and channel 3 [CH3]
(The system default elevator is already the second channel. We can set the channel 3 throttle to the
elevator.)
Click the button on the left side of the row as shown below. The channel function selection interface pops
up. Click the elevator button to pop up the confirmation window. Select “Yes” to save the settings.
Function
Aileron Flight M1 AUX2 Engine2
Elevator Flight M2 AUX3 Fuel mix
Throttle Gyro AUX4
Rudder Gyro2 AUX5
Gear Gyro3 AUX6
Motor AUX1 Engine1
After the [Function] function is
adjusted, you may need to adjust the
following parameters: [End Point],[
Sub-trim ], [Servo Reverse], [Fail Safe],
etc.
056
General Menu
Fine adjustment switch select
Function select
Function
5
4
3
2
1
Aileron
Elevator
Throttle
Rudder
Gyro
Contrl Trim
J1 T1
J3 T3
J2 T2
J4 T4
- - - -
1/3
NOTICE