Wfly ET Series, Instruction Manual

Page: 60 / 131

Timer
Interface path: WFLY → [General Menu] → [Timer]
This timer function can be used for a variety of timings such as the total flight duration and the specific
time of the game. Timer 1 and Timer 2 can be set and displayed on the main standby screen.
The timer is an independent function in each model. When the model is changed, the timer
corresponding to the new model will be automatically recalled.
The timer can be started or stopped by operations such as switches or joysticks. And the direction of the
start and stop switches can be set automatically. Positive timing and countdown can be set to a maximum of
99 minutes and 59 seconds.
1/3 Timer
UP
Timer1
Alarm
Mode
Vibrator
Memory
00
INH
INH
- -
Reset SW
Start SW
Stop SW
- -
- -
Remainder 00
00:00.0
Click to start timing
Click again to pause
Press & hold to reset
After some time, start the timer
reminder once every 1 minute.
Remaining time, the remaining
time of the distance alarm
reduced every 1 minute.
Reminder every minute, ring for
1 minute.
Minute:0-99
Seconds
:
0-59
Reset, start, close,it can be
operated by switches and the like.
UP: starting from 0, increasing
with time
Down: decrease from the set
time
INH, turn off the power or replace the new model and reset the timer to
zero clearing.
ACT, Memory of the previous timing data while rebooting.
Click to switch
To timer 2
Case Setting (timer 1 15 minute countdown,
ringing alarm, open vibration, switch SA control):
1 Time setting, as shown on the right, warning bar,
the left minute value is adjusted to “15”, and the
right side is set to “Remaining time”
2 Mode setting, mode is set to “countdown”.
3 Vibration setting, vibration is set to “Vibration
1”.
4 Memory setting, open as needed, keep the
default here.
5 Switch setting, the start switch is set to “SA/2
gear”, the stop switch is set to “SA/1 gear”, and the
reset switch is set to “SA/0 gear”. (So we can control
the timer 1 with just one switch)
After the activation and activation effect: the
timing starts, the reminder becomes a continuous
“tick-tick-tick...” sound when the remaining 20
seconds, and the reminder becomes continuous
“ticktick-ticktick-tick” when 10 seconds left. The
sound of “tick...", at the end of the countdown, there
will be a long beep with the vibration of the type
"Vibration 1"; then the timing will continue and show
a negative value.
1/3 Timer
Do wn
Timer1
Alarm
Mode
Vibrator
Memory
15
Vibrate1
ACT
SA
Reset SW
Start SW
Stop SW
SA
SA
Elapsed 00
00:00.0
V
5.0
Receiver External
V
12.0
00:00.0
00:00.0
Home1 RX Condition1 12.9V
Timer 1
Timer 2
Click to start timing
Click again to pause
Press & hold to reset
Standby
interface
WFLY
0 - 1000
Home2
00:00.0
Model 1
User Name
12.0V External
5.0V
Receiver
00:00.0
00:00.0
+ 25 + 1000
- 500 - 500
ET12 RX Condition1 12.9V
3/3 Timer
Model time
Mode Power on
00
:
00
.
0
Model time:the accumulated time of model
working,the account unit is hour-miunte-second.
Control mode:boot timer, or switch/stick(such as
throttle stick)
060
General Menu