Receiver Instructions
Receiver LED STATUS LIST
Link:
Charge the receiver then press and hold
'SET' button for 3 seconds,wait for the link
instruction after the orange light slowly flashes.
PPM/W.BUS/PWM port modes select:
Click and
hold the “SET” to charge, then enter into model
setting, slightly click the switcher mode, press and
hold to confirm.
Receiver mode switching:
The receiver works in
"mode A" by default, and the receiver interface
output data according to the sticker serial number.
Switching the "mode" to the code will change the
interface output mode. You can use multiple
receivers to output more channels. More details,
please check [Linkage Settings - Link]
Receiver connection and installation
The working voltage of the receiver is 3.7-13V.
Each port can be used as the power input terminal.
Notice:
pay attention to the positive and negative
polarity when connecting the power supply. Do not
use the power supply that exceeds the working
voltage of the receiver. Otherwise, the receiver will
be damaged!
The RF209S is the newest series of high
performance receiver with 9 PWM channels, 1
PPM/W.BUS channel (User defined), and 1 W.BUS2
channel (User defined).
In order to obtain optimal signal retrieval
performance, the two antennas are preferably
processed 90° to each other when installed, as
shown in the right diagram.
Mode
LED
Action
Status
Work
Purple
On
PWM normal work mode
Green
On
W.BUS normal work mode
Blue
On
PPM normal work mode
Red
On
No signal
Red
Slow flash Low voltage
Orange Slow flash Linking
SET
Green Slow flash W.BUS mode
Blue
Slow flash PPM mode
Purple Slow flash PWM mode
1.If there is a metal conductor around the receiver antenna,the signal performance would be affected.
In this case, the antenna should be bypassed by the conductor, placed on both sides of the fuselage, and
it is better to make the antenna leak outside the model casing ! In this way, good signal reception can be
maintained regardless of the flight attitude.
2. When the antenna is installed. The unshielded end of the antenna should be as far away as possible
from the conductor materials such as metal and carbon fiber. The antenna cable avoids bending at large
angles. And the end core should be as straight as possible.
3. If the model body is covered with a conductive material such as carbon fiber or metal, the antenna
portion must be extended beyond the body. At the same time, do not stick too close to the conductive body
after the antenna is extended. In addition, the antenna should also be kept away from the fuel tank.
The receiver has an external battery detection interface, which can be used to view voltage information
such as ESC, battery, etc., and the transmitter can separately set alarm voltages for the receiver voltage
and external voltage. Pay attention to the positive and negative polarity when using the detection wire!
90°
E
x
te
rn
a
l v
o
lt
a
g
e d
e
te
c
tio
n p
o
rt
Ext
.
voltage
External voltage detection port
Port polarity mark
The resistance is
connected to the negative pole
The red is
connected to the positive pole
Antenna
Keep straight
USB port
Signal
Positive
Negative
8 7 6 5 4 3 2 1
9
PPM/PWM
W.BUS/PPM/PWM
W.BUS2/W.BUS/
PPM/PWM
018
Basic Operation
Mandatory
1Ω
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...
