Wfly ET Series, Instruction Manual

Page: 70 / 131

Throttle Hold
Interface path: WFLY → [Model Menu] → [Throttle Hold]
This function sets the throttle in the cut position during landing. The throttle servo speed can be adjusted.
Note: The throttle hold is associated with flight conditions and the throttle hold function must be set
separately with different flight conditions.
The set throttle hold
output position
Current throttle position
Set [Throttle hold] function
switching response speed with
Range 0-100, Default 0 , no
conflict with [Condition] delay.
Place the stick on the throttle
position you want to hold with
Range 0%-50% and Default
17% , press +/- button or click
UP/DOWN button to adjust the
value, or click the value button
or the confirmation button to
get the position(POS).
Function application instruction
When the helicopter is performing a landing action, the propeller is generally required to operate at low
idle speed in order to land safely and smoothly.
However, the working principle of electric helicopters and oil-powered helicopters is different. The
setting here needs to distinguish the “holding position” of the throttle according to the model power, and
make adjustments according to the actual application.
The operation of the electric helicopter is more flexible than the oil engine, so it can be set low or closed
(depending on the actual situation).
The engine of the oil-powered helicopter runs, and the acceleration and deceleration dynamic response
time is much longer than that of the motor, so the "holding position" needs to be higher than the motor type.
17 %
Throttle Hold
Status
Switch
- -
INH
Hold pos
Delay 0
Control switch
070
Model Menu\Helicopter
When flying, be sure to turn off the
“stunt” function. The warning switch
can be used to start the engine at idle
down.
WARNING