Wfly ET Series, Instruction Manual

Page: 49 / 131

Range Check
Range Check
Pull the switch(SH) to reduce the
power of transmitter.
Power is normal
Signal strength 100%
Interface path: WFLY → [Linkage Setting] →
[Range Check]
The range checkt is mainly used to test the
distance.
Turn on the telemetry when linking. After linked,
the transmitter receiver can be connected normally
to use this function! Only enter this interface, after
toggling the SH switch, the power will be reduced!
The control distance is related to the actual use
environment!
Instructions:
1. Enter the interface and toggle the SH switch.
2. The transmitter and receiver maintain a certain
height (about 1.5 meters above the ground) and the
antennas are in the same direction (perpendicular to
the ground).
3. The transmitter and receiver are powered, start
moving position, and move the stick.
4. The transmitter checks the signal strength on
the interface, and the receiver checks whether the
status light and the servo dual rate are smooth. The
above bring the comprehensive evaluation of the
working distance!
1
Transmitter antenna
Vertical ground
90°Upside
2
Approximately distance
from the ground
1.5M high for testing!
3
Receiver antenna
90° to each other
Open area
*
[Rage Test] The results are for reference only and are not intended as the only performance
standard, depending on the specific usage environment!
90°
Signal strength judgment:
The transmitter signal strength returned by the
receiver can be viewed in the upper right corner of
the screen status bar (the standby interface during
normal operation) and the signal strength
percentage indication ([Range Test] function
interface). The more indicator bars, the larger the
percentage value. The better the signal, conversely,
the worse signal. The status bar has no signal bar
indication, and there is no signal when the signal
strength is 0%.
049
Linkage Setting