Wfly ET Series, Instruction Manual

Page: 79 / 131

Fuel mixes
THR cut
Hold pos
.
Tuning
Mode
Status
17
%
17
%
+0% +0%
- -
UNMIX
INH
1/3
Fuel Mix
Fuel mixes
Rate
Dumping
Act pos.
0%
0% 0
%
Low High
25
%
75
%
100%
2/3
Fuel mixes 3/3
+150
+100
+50
0
-50
-100
-150
+150% RATE +150% POS
Offset Type
0% EXP1
Rate B Rate A
+100% +100%
EXP B EXP A
0% 0%
Optional 3 curves, EXP1, EXP2, polyline
Up and down the overall offset curve, adjust the center point
Ratio on the left side of the curve and ratio on the right side, range ±200%
EXP's left curve ratio and right curve ratio, range ±100%
Mixing mode,non mixing mode
[Fuel Mix] Disabled,Enable
[Fuel Mixe] trimming controlling switch of current flight condition
0 Trim ratio, range±30% ， %
default 0
Current control switch position
Throttle cut controlling position, range 0~50%
,
default 17%
Throttle lock controlling position, range 0~50%
,
default 17%
Accelerate adjustment setting
This function is used to adjust the acceleration performance of the engine/oil needle. The operation of
temporarily increasing the oil needle while operating the throttle stick accelerates the engine. This function
is used for excessive or low oil-to-air mixing ratios caused by sudden throttle stick operation. (When using
the acceleration adjustment setting function, since the oil needle adjustment range is large, adjust the
setting so that there is no dead zone in the entire connection travel.)
High and low adjustment rate setting
Recovery time after adjustment operation
Interface path: WFLY → [Model Menu] → [Fuel Mix]
The function is used to improve the mix control of engine needle adjust and control carburetor during
flying.
Engine cut setting
This function is connected to the [Throttle Hold] function, the [Throttle Cut] function, and the [Idle Down]
function. Adjust the throttle cut position according to the specific situation. Set to the fully closed position.
Flight conditions: Set the "Flight Condition" control switch in [Model Menu] → [Condition]. Switching is
performed by switches, and function settings are made separately.
Range 0-50%, default 25%, click to get the throttle stick position
Range 51-100%, default 75%, click to get the throttle stick position
The current position value of the throttle stick
Note: In the default setting, the [Fuel Mixes] function is not defined on any channel. Before using this
feature, select an unused channel on the receiver and assign it to this mix function. Also, confirm that
"Control Switch" and "Trim" are set to [--].
079
Model Menu\Helicopter