Wfly ET Series, Instruction Manual

Page: 82 / 131

Model Menu\Airplane
Condition
Interface path: WFLY → [Model Menu] → [Condition]
With this function, flight conditions can be configured as needed, and there are 5 flight conditions to
choose from.
If you do not need to use the conditional switching function, you do not have to set it on this page. The
default configuration can be used directly.
When multiple flight conditions are set, the priority between them is to prioritize the final flight conditions!
Delay: Avoid swaying of the fuselage caused by sudden changes in the position of the servo or the
unsynchronized action time between the passages when switching flight conditions.
Switch instruction
Condition
Logic
Mode
Logic
Or
Switch B
- -
Switch A
- -
Separate mode (single switch control).
Logic mode (combination switch control).
"AND" mode: The flight conditions can be switched when
both switches are turned on.
"OR" mode: As long as one switch is turned on, the flight
conditions can be switched.
XOR mode: When the positions of the two switches are
reversed, the flight conditions can be switched.
* "On", "Off": When the switch is selected, the selected gear
position or position
Condition
9 4
8
10
3
5
7 2
6 1 Aileron
Elevator
Throttle
Eleva2
Rudder
Aileron2
Flap
Flap2
Gear
Camber
0
0
0
0
0
0
0
0
0
0
1/2
Channel Channel Delay Delay
Condition
- -
- -
- -
- -
Delay
Condition2
Condition3
Condition4
Condition5
Condition1
12 channels can be
individually set to delay
Assign control switch: By default, there is no switch
assignment (--), click to enter the assignment interface.
Switching between flight conditions can be performed using
switches such as a toggle switch, a stick, and a lever. Set the
unwanted flight condition switch to empty (--).
For each flight condition, the
corresponding delay can be set
separately, and the set control
switch can be activated to set
the delay value of each channel
corresponding to the flight
condition.
Rename: Which condition
needs to be modified, click on
the name bar on the left to
directly rename the operation.
Press and hold the 5-way button
to reset the default name.
Delay configuration
interface point
082