Throttle Hold
Interface path: WFLY → [Model Menu] → [Throttle Hold]
This function sets the throttle in the cut position during landing. The speed of the throttle servo can be
adjusted.
Note: The throttle hold is associated with flight conditions and the throttle hold function must be set
separately for different flight conditions.
The set throttle lock output position
Current throttle position
Set the response speed of the
[Throttle hold] function switch
with Range 0-100 and the
default 0 , and there is no
conflict with the [Condition]
delay.
Place the stick on the throttle
position you want to hold with
Range 0%-50% and default
17%,
click the value button or
the confirmation button to get
the position(POS.).
Function application instruction
When the electronic helicopter is performing a landing action, the propeller is generally required to
operate at low idle speed in order to land safely and smoothly.
However, the working principle of electric helicopters and oil-powered helicopters is different. The
setting here needs to distinguish the “hold position” of the throttle according to the model power, and make
adjustments according to the actual application.
The operation of the electric helicopter is more flexible than the oil engine, so it can be set low or closed
(depending on the actual situation).
The engine of the oil-powered helicopter runs, and the acceleration and deceleration dynamic response
time is much longer than that of the motor, so the "lock position" needs to be higher than the motor type.
17%
Throttle hold
Status
Switch
- -
INH
Hold pos.
Delay
0
Control switch
127
Model Menu\Multicopter
When flying, be sure to turn off the
“idle” function switch , start the engine
at idle down.
WARNING
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...
