Throttle Cut
Throttle Cut
Status
Switch
Cut Pos.
Throttle
17
%
17
%
- -
INH
Interface path:WFLY→ [Model Menu]→[Throttle Cut]
Safely and easily to turn off the engine. Throttle cut provides an easy way to stop the engine from
running. Generally speaking, it can be realized by dialing a hardware switch in an idle state. This function
cannot be triggered when the throttle is high to prevent any mis-operation. The position and direction of the
switch must be selected because the initial setting is [--]
The selected hardware cut switch adjusts the ratio value when the throttle and throttle lever are idle
down, until the engine can be completely shut down.
In addition, verify that the throttle link is not tightened or that the servo is not overloaded.
The set cut position
Current position of throttle stick
Cut position setting
1 Status is switched to "ACT”
2 Click the “Switch” button to pop up the “Switch Assignment” interface and select the control switch.
3 Turn on the selected “cut control switch”, the engine stick is in the idle down state, adjust the rate until
the engine (motor) stops completely.
Please pay attention to the throttle connection here, do not let the servo exceed the travel.
The "cut position" must not be set
higher than the lowest speed throttle
position. It is dangerous if the engine
runs at high speed.
Set the throttle trigger position
071
Model Menu\Helicopter
DANGER
Place the stick on the throttle
position you want to hold with
Range 0%-50% and Default
17% , click the value button or
the confirmation button to get
the position(POS).
Control switch
Summary of Contents for ET Series
Page 52: ...052 Linkage Setting ...
Page 130: ...130 ...
