VIPA System 200V IM Series, Manual

Page: 53 / 348

Manual VIPA System 200V
Chapter 3 Profibus DP
HB97E - IM - Rev. 06/29 3-21
Depending on the used firmware at CPU and DP master, you have the
following transfer possibilities:
1. Transfer via MPI (only for 1
st
master at the bus)
Your DP master project is transferred to the CPU together with the PLC
program. The CPU transferees the DP master project automatically to
the 1
st
master at the bus system (IM 208DP or CPU 21xDPM) at Power
ON.
2. Export of the project as wld-file to MMC
Export your project as wld-file and transfer it to a MMC. The MMC is to
plug in the according DP master.
3. Only IM 208DP: Export of the project as wld-file and data transfer via
Green Cable deploying the SIP-Tool from VIPA.
10. Connect your PG res. your PC via MPI with your CPU.
For a serial point-to-point transfer from your PC, you may also use
the Green Cable from VIPA.
The Green Cable has the order no. VIPA 950-0KB00 and may only
be deployed at compatible modules from VIPA. Please regard the
instructions to the Green Cable further down!!
At deployment of the Green Cable from VIPA, the MPI interface has
to be configured (PC Adapter MPI, 38400Baud).
11. Switch your DP master to RUN.
12. Switch on the power supply of the CPU.
13. Transfer your project into the CPU with
PLC
>
Load to module
in
the hardware configurator from Siemens.
14. For additional saving of your project on a MMC, you plug a MMC in
the CPU slot and transfer the project via
PLC
>
Copy RAM to ROM.
During write operation, the "MC"-LED at the CPU is blinking. Due to
the system, the successful write operation is announced too soon.
Please wait until the LED extinguishes.
Now the project engineering is completed.
Note!
Please regard also that this allows you only to configure the 1
st
master in
the system! Additional DP masters have to be exported as wld-file and
loaded to MMC.
Transfer variants
to 1.
Transfer via MPI