VIPA System 200V IM Series, Manual

Page: 290 / 348

Chapter 7 SERCOS - Spare part
Manual VIPA System 200V
7-8 HB97E - IM - Rev. 06/29
Basic parameterization via address adjuster
Via the address adjuster you may alter basic settings of the SERCOS
coupler. Choose the according address code at the shut-down SERCOS
coupler. At power on, this code is stored permanently in the SERCOS
module.
The following basic settings may be altered in this way:
•
Baudrate
•
Light intensity
•
Time window calculation
Note!
Please regard, that you may use the address adjuster only in off state.
Otherwise malfunctions of the SERCOS couplers may occur!
Turn off the supply voltage of the SERCOS coupler.
Choose the according address code at the address adjuster.
Turn on the voltage supply.
→
The assigned parameter is permanently stored in the SERCOS
coupler and this is shown via the green RD-LED.
00: reserved (may not be used)
01 ... 89: possible SERCOS station addresses
90 ... 99: VIPA additional functions for basic parameterization
All participants connected together at the bus are communicating at the
same baudrate. You may fix the wanted baudrate via the address adjuster.
•
Turn off the voltage supply.
•
Choose the wanted baudrate at the address adjuster. Here means:
90: 2Mbaud
91: 4Mbaud
92: 8Mbaud
93: 16Mbaud
•
Turn on the voltage supply.
→
The assigned baudrate is permanently stored in the SERCOS coupler
and this is shown via the green RD-LED.
Overview
Approach
Value range
Fix baudrate