VIPA System 200V IM Series, Manual

Page: 291 / 348

Manual VIPA System 200V
Chapter 7 SERCOS - Spare part
HB97E - IM - Rev. 06/29 7-9
You may predefine the light intensity of the FO diode in 4 steps.
•
Turn off the voltage supply.
•
Choose the wanted light intensity at the address adjuster. You have
following possibilities:
94: light intensity 0 (Minimum)
95: light intensity 1
96: light intensity 2
97: light intensity 3 (Maximum)
•
Turn on the voltage supply.
→
The assigned light intensity is permanently stored in the SERCOS
coupler and this is shown via the green RD-LED.
Set here the operating mode for the time window calculation. The following
2 modes are possible:
98: Mode_All_Cyclic
The complete periphery is available in the cyclic SERCOS operation.
Additionally you may also use the service channel. Depending on the
number of modules you need SERCOS cycles of 2ms or more. The more
periphery is connected, the higher you have to choose the SERCOS cycle
time.
99: Mode_All_Service_Channel
In this mode, no periphery is available in the cyclic operation. For this you
may operate the SERCOS ring with a cycle time of 1ms. Here you may
address the peripheral modules exclusively via the service channel.
Fix light intensity
Time window
calculation