VIPA System 200V IM Series, Manual

Page: 27 / 348

Manual VIPA System 200V
Chapter 2 Assembly and installation guidelines
HB97E - IM - Rev. 06/29 2-9
•
Install the connector on the module until it locks with an audible click.
For this purpose you press the two clips together as shown.
The connector is now in a permanent position and can easily be wired.
The following section shows the wiring procedure from above.
•
Insert a screwdriver at an angel into the square opening as shown.
•
Press and hold the screwdriver in the opposite direction to open the
contact spring.
•
Insert the stripped end of the hook-up wire into the round opening. You
can use wires with a diameter of 0.08mm
2
to 2.5mm
2
(1.5mm
2
for
18pole connectors).
•
When you remove the screwdriver, the wire is clipped securely.
Wire the power supply connections first
followed by the signal cables (inputs and outputs).
Wiring procedure