VIPA System 200V IM Series, Manual, Page: 72 / 348

Chapter 3 Profibus DP
Manual VIPA System 200V
3-40 HB97E - IM - Rev. 06/29
0 1
This address selector is used to configure the address for the bus coupler.
Addresses may range from 1 to 99. Addresses must be unique on the bus.
The slave address must have been selected before the bus coupler is
turned on.
When the address is set to 00 during operation, a once-off image of the
diagnostic data is saved to Flash-ROM. Please take care to reset the
correct Profibus address, so at the next Power ON the right Profibus
address is used!
Every Profibus slave coupler has an internal power supply. This power
supply requires DC 24V. In addition to the electronics on the bus coupler,
the supply voltage is also used to power any modules connected to the
backplane bus. Please note that the maximum current that the integrated
power supply can deliver to the backplane bus is 3.5A.
The power supply is protected against reverse polarity and over current.
Profibus and backplane bus are galvanically isolated from each other.
Attention!
If PW is not on when the unit is connected to power, the internal fuse has
blown!
Configure the slave like shown below; the project engineering is for all
System 200V Profibus slaves identical.
To include the 24 outputs, you should additionally plan the module
VIPA 253-2DP20 for the first slot. Seen from the hardware side, the
module is directly beside the slave.
Address selector
Power supply
Configuration of
the outputs