Viavi CellAdvisor 5G, User Manual

Page: 348 / 359

Using RFoCPRI Analyzer
336
5 Tap Port Type to Slave (default).
Port Configuration with RFoCPRI Analyzer
Conducting spectrum measurement
After setting test parameters as described in “
Configuring test parameters
”, you can perform spectrum measurements with an
audible indicator. You can also turn on the interference ID.
1 Tap the Setup ( )icon on the side bar of Spectrum Measure mode.
2 To set the sound indicator, complete the following steps:
a Tap Sound Indicator > Alarm Reference then, choose either Marker or Line .
–
Marker : Sets the active marker position as the alarm reference if you have enabled a marker on the spectrum.
–
Line : Makes the reference line as the alarm reference.
b If you have set the alarm reference to Line , tap the Reference Line to set a threshold for an alarm.
c Enter a value by t or -, and tap Apply .
d Tap Sound either On or Off to turn on/off the alarm sound.
e Optional. To adjust the volume for alarm sound, tap Volume , and adjust the volume.
NOTE:
The Sound Indicator is used to identify interfering signals with alarm sound. It is especially useful for locating
interferer sources with a directional antenna.
3 To set the interference ID, complete the following steps:
a Tap Interference ID and Threshold .
b Enter a value and tap the dBm .