Viavi CellAdvisor 5G, User Manual, Page: 140 / 359

Using LTE/LTE-A FDD Analyzer
128
Tap to switch to the full screen map view.
Tap to zoom in the map.
Tap to zoom out the map.
Tap and select the area where you want to expand.
Setting measure setup
Before starting the Route Map measurement, you need to set Spectrum measurements displayed on the quick access and display
tab. See "
Configuring Spectrum Measurements " for more details.
1 If required, connect a GPS receiver to your CellAdvisor 5G for outdoor mapping. Indoor mapping does not necessarily need a
GPS antenna.
2 Tap the Setup ( ) icon on the side bar.
3 Tap to switch the Plot Point to GPS or Position .
a To collect data/plot points automatically as you move around in a vehicle or outside (outdoor), select GPS and then tap to
switch to the Screen Mode between Map and Full .
With the Map setting, you can view only the collected points that can be seen within the boundary of the loaded map.
With the Full setting, you can view all the collected points of the route without the loaded map.
b To collect data/plot points manually in indoor layout without a GPS antenna, select Position .
4 Tap to switch Plot Item to RSRP , RSRQ , S-SS SINR , S-SS RSSI , P-SS RSRP , S-SS RSRP , S-SS Ec/Io , or P-SS SNR .
5 Tap Bandwidth and select the value from the following choices: 1.4 MHz , 3 MHz , 5MHz , 10 MHz , 15 MHz, or 20 MHz .
NOTE:
The instrument does not automatically save the collected data. It is recommended that you save the result.
Otherwise, you will lose all the collected data.
Logging data
1 Follow the step 1 to 3 in Setting measure setup.
2 Tap the Start button ( ) on the right panel of the map to start plotting on the map.
When you select a point on the map, a marker appears and the Information window appears on the right panel.
3 Tap the Stop ( ) button to stop plotting.
4 Tap the Pause button ( ) to pause plotting, then the Pause button changes to ( ) and GPS point cannot be
plotted.
5 Save the logging file to your USB.
Viewing the logging data
1 Load the saved logging file using the Load icon ( ) on the side bar. Make sure the file extension is
.gomv
.