About CellAdvisor 5G
2
Safety and compliance information
Product Regulatory compliance
Federal Communications Commission (FCC) notice
This product was tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this product in a
residential area is likely to cause harmful interference, in which case you will be required to correct the interference at your own
expense.
The authority to operate this product is conditioned by the requirements that no modifications be made to the equipment unless the
changes or modifications are expressly approved by VIAVI.
Caution:
– To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between
the antenna of this device and all person.
– This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada requirements
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This Class A digital apparatus complies with Canadian standard ICES-003.
Le présent appareil numérique de classe A est conforme à la norme ICES-003 du Canada.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Device operation in the band 5150
–5250 MHz is for indoor use only.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: 1) l'appareil ne doit pas produire de brouillage; et, 2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Dans la bande de fréquence 5150-
5250 Mhz, l’utilisation du produit doit être uniquement en intérieur.
Japan Ministry of Internal Affairs and Communications (MIC) Requirements
This device is compliant with Jap
an’s Radio Law and the Technical Conformity (Giteki) Mark can be viewed on the instrument’s
display screen. The telec.pdf file containing the conformity mark is located in the files/disk/licenses folder under the System menu.
EU WEEE and battery directives
This product, and the batteries used to power the product, should not be disposed of as unsorted municipal waste and should be
collected separately and disposed of according to your national regulations.
VIAVI has established a take-back processes in compliance with the EU Waste Electrical and Electronic Equipment (WEEE)
Directive, 2012/19/EU, and the EU Battery Directive, 2006/66/EC.
Instructions for returning waste equipment and batteries to VIAVI can be found in the WEEE section of
If you have questions concerning disposal of your equipment or batteries, contact VIAVI WEEE Program Management team at
Summary of Contents for CellAdvisor 5G
