Chapter 5 - Fuselage
5.17 - Upper fuselage assembly
Page 83
5.16.2
the rear seats
The placement of the lower rear seat is also somewhat controlled by the height of
the front-mounted panel (reinforcement at the top of the landing gear box), and the
location of the rear seat backrest. Place the rear seat against the rear backrest, lower until
the lower part of the seat touches the undercarriage reinforcement, mark this inclination
for gluing the seat backs. Cut the 2-layer prepreg panel panels into place. Make
adjustments as necessary.
Prepare the surfaces for gluing and dig the core of the panel where it will be in
contact with the other surfaces. Prepare a FLOX paste and pass over the place taking the
opportunity to make a small radius. Laminate the pieces with 2-ply 2-inch-wide BID tape.
5.17
Upper fuselage assembly
5.17.1
entrance naca
Review the design of the entry in the casing (Center line 140mm from the lower
edge of the lower edge of the upper fuselage and the rear edge of the design 320mm from
the front edge of the upper fuselage).