Chapter 5 - Fuselage
5.9 - Front floor assembly
Page 62
prepare one FLOX paste and pass over the lower edges of the supports, position
these over the proper places and with the paste create a small radius on the edges for the
lamination. Glue in place with a BID tape in 2 layers in 2 inches width. After these
brackets are cured, cut out the 2 inch edges left in the center section of the top panel and
prepare the separate top sections and rear closure sections in the same way as the brackets,
test them for fit as well, and make any necessary adjustments. put a FLOX paste over the
open cavities in the core of the panels and place them in their proper place, use the paste
and make a small radius in the corners. Glue in place with a BID tape in 2 layers in 2
inches width. Place weights on floors and allow to cure.