Toshiba E-STUDIO2008A, Service Manual, Page: 550 / 1016

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 12
EA26 Finisher jam
(Finisher section) Paper transport jam (stop command request): A
command to stop equipment operation is received
while paper is being transported in the Finisher.
[MJ-1101/1107/MJ-1106/1108]
Paper transport jam in the Finisher (stop command
request): The equipment is required to stop during
the transporting of paper in the Finisher.
[MJ-1032/MJ-1033]
P. 8-120
EA27 Paper transport jam (paper not inserted): The
equipment detects a paper-not-inserted jam but the
entrance sensor is turned ON before the equipment
is stopped. [MJ-1101/1107/MJ-1106/1108] P. 8-120
EA28 Paper transport jam (paper holder plate operation
delay): An attempt to start the arm assisting
operation for dropping paper on the finishing tray is
made, but the previous arm assisting operation has
not yet been finished. [MJ-1101/1107/MJ-1106/
1108] P. 8-120
EA29 Paper transport jam (stack transport delay): The
buffer tray is extended to drop a stack of paper on
the finishing tray but the previous stack has not yet
exited. [MJ-1101/1107/MJ-1106/1108] P. 8-120
EA2A Paper transport jam in the Finisher (between the
entrance path and middle path sensor): The leading
edge of the paper has passed the entrance path
sensor, but does not reach the middle path sensor
in the Finisher Unit transport path. [MJ-1032] P. 8-123
EA2B Paper transport jam in the Finisher (middle path
sensor): The paper remains at the middle path
sensor for a longer period than specified while
being transported on the Finisher Unit transport
path. [MJ-1032] P. 8-124
EA2C Paper transport jam in the Finisher (between the
entrance path and sub-path sensor): The leading
edge of the paper has passed the entrance sensor,
but does not reach the sub-path sensor in the
Finisher Unit transport path.
[MJ-1032] P. 8-124
EA2D Paper transport jam in the Finisher (sub-path
sensor): The paper remains at the sub-path sensor
for a longer period than specified while being
transported on the Finisher Unit transport path.
[MJ-1032] P. 8-125
EA2E Paper transport remaining jam in the Finisher (sub-
path sensor): Paper is detected in the sub-path
sensor when the power is turned ON or the cover is
closed. [MJ-1032] P. 8-125
EA31 Transport path paper remaining jam.
[MJ-1101/1107/MJ-1106/1108]
Paper transport remaining jam in the Finisher:
Paper is detected in the entrance path sensor or
middle path sensor when the power is turned ON or
the cover is closed. [MJ-1032]
Paper transport remaining jam in the Finisher:
Paper is detected in any of the path sensors when
the power is turned ON or the cover is closed.
[MJ-1033]
P. 8-126
P. 8-126
P. 8-127
Error code Classification Contents Troubleshooting