6
© 2015 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 69
6.12.5
Adjustment of horizontal position
Notes:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with a center line in the following procedure.
(1)
Place the chart provided as an original with its face up on the original tray of the RADF.
(2)
Press the [START] button.
(3)
Fold the copy in half and check if the center line is misaligned.
[B] Adjustment
(1)
Performs FS-05-3043.
•
If the center line of the copy image is shifted to the front side of the equipment, enter a value
larger than the current one.
Notes:
Changing one value shifts the copy image by 0.042 mm.
Fig.6-73
•
If the center line of the copy image is shifted to the rear side of the equipment, enter a value
smaller than the current one.
Notes:
Changing one value shifts the copy image by 0.042 mm.
Fig.6-74
(2)
Press the [OK] button.
G
H