187
© Tieline Research Pty. Ltd. 2020
Genie Distribution WNET Manual v3
Important Notes:
·
When you decide to use an existing program as a template, the new program inherits
all the settings of the template program and you can adjust these settings as required
by continuing through the program wizard.
·
If the codec you are configuring needs to be capable of dialing 2 x mono peer-to-peer
connections, as well as answering two incoming mono peer-to-peer connections, select
Dial or answer
and configure both dialing and answering connections in this program.
If you only configure dialing connections within the program and the codec receives a
call from a codec requesting a mono peer-to-peer connection, the codec will allow this
first connection but will not allow a second incoming mono peer-to-peer connection. For
the purposes of this outgoing 'distribution' example, answering is excluded. For more
details about configuring answering connections for 2 x mono peer-to-peer connections
see
Configure 2 Mono Answering Peer-to-Peer Connections
3. To configure new program level rules click the drop-down arrow and select the preferred option
from those available. Click the blue
Plus symbol
to add a new rule and click the
Minus
symbol
to remove a rule.
Important Notes for Rules:
·
The codec has 4 physical
CONTROL PORT GPIOs
; 7 Tieline and WheatNet virtual
inputs (1-7); 64 Tieline virtual logic outputs; and, 64 virtual WheatNet logic outputs
(these allow Tieline WheatNet-IP enabled codecs to activate functions across a
WheatNet-IP network). See
·
Virtual inputs 5-7 can be activated by pressing the
F1
button and
KEYPAD
buttons 1-3.
·
A non-WheatNet-IP Tieline codec can be configured to trigger a WheatNet LIO in a
Tieline WheatNet-IP codec.
·
Tieline WheatNet-IP codecs require Wheatstone Razor firmware version 1.4.22 or later
to support WheatNet LIOs. In addition, the WheatNet-IP codec must have the
WNet
Enable LIO
checkbox
selected in the
Options panel
of the HTML5 Toolbox Web-GUI.
·
Relay reflection is not available for SIP and Multicast Client programs.
·
Connection-related rules are not displayed in
Answer only
audio streams.
·
Rules intended to activate dialing will not be valid in
Answer only
programs or audio
streams.
·
For more details about rules see
4. Enter a
Stream Name
, then add a
Caller ID
and configure the codec to
Dial only
. Then click
Next
. Note: The caller ID is used to identify calls.