368
Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
Good Quality:
This setting lies between "Best Compromise" and "Highest Quality." It may assist in
achieving higher quality connections without incurring extreme delays in transmission or significant
packet loss.
Highest Quality:
This setting is the most conservative in terms of adapting to prevailing network
conditions to reduce delay. The jitter-buffer will remain higher for a longer period after a jitter spike is
detected – just in case there are more spikes to follow. This setting is best to use where audio
quality is the most important factor and delay is not as critical. Unless delay is irrelevant, this
setting is not recommended over peaky jitter networks (e.g. cellular networks) and is best used on
more stable networks where fluctuating jitter bursts are not common.
Jitter Depth
The jitter
Depth
setting allows you to select predetermined minimum and maximum jitter settings
within the auto jitter buffer's minimum and maximum jitter limitations. The default setting of
60 to
1000ms
is a good starting point for most networks. It may be necessary to increase the maximum
auto jitter latency setting for networks experiencing higher packet latency, or the minimum depth
depending on the reliability of the network.
Which Algorithms Support Automatic Jitter Buffering?
The following table provides an overview of which algorithms are capable of using the automatic jitter
buffer feature over SIP and non-SIP connections.
Algorithm
Tieline Session Data
Connections
SIP Connections
Linear (Uncompressed)
Tieline Music
Tieline MusicPLUS
G.711
G.722
MPEG Layer 2
MPEG Layer 3
LC-AAC
HE-AAC v.1
HE-AAC v.2
AAC-LD
AAC-ELD
Opus
aptX Enhanced
Configuring Automatic Jitter Buffering (Default Setting)
1. Press the
HOME
button to return to the
Home
screen.
2. Use the navigation buttons on the front panel to select
Connect
and press the
button.
3. Select
IP
and press the
button.
4. Select your preferred
IP Session
mode and press the
button.
5. Use the down
navigation button to select
Setup
and press the
button.