15
© Tieline Research Pty. Ltd. 2020
Genie Distribution WNET Manual v3
5
Genie Distribution with WheatNet Rear Panel
XLR Analog Inputs
XLR
IN1
and
IN
2
are balanced line inputs.
XLR Analog Outputs
XLR
OUT 1
and
2
are balanced analog audio line outputs.
Dual Gigabit Ethernet Ports
The codec features two Gigabit (10/100/1000) RJ-45 Ethernet ports for IP connections. By default,
the codec assumes
ETH1
is the primary LAN connection and
ETH2
is the backup LAN connection
when in use. If you are only using one Ethernet port, always use
ETH1
. Note: When connected to a
1Gigabit link the green Ethernet port LED is illuminated solid green. When attached to a 100Mb link,
the green Ethernet port LED is not illuminated.
WheatNet Audio LAN Port
Transport WheatNet-IP audio using a purpose built rear panel and the Tieline WheatNet-IP audio
card. This optional rear panel provides a LAN interface for connecting directly to a WheatNet-IP
network and transport IP audio to external sites over IP networks like the internet.
Aux Mic/Line Input
AUX IN
6.35mm (1/4") balanced auxiliary mic or line input.
Headphone Out/Aux Line Out
HP/AUX OUT
6.35mm (1/4") software configurable stereo headphone output, or balanced auxiliary
line output. The front panel
HEADPHONE
output and rear panel
HP/AUX OUT
share the same
hardware output. This means both are switched and configured together. I.e. both outputs are either
a stereo headphone output (default setting), or a balanced mono auxiliary output.
Command & Control Interfaces
1. Four relay inputs and four opto-isolated outputs for machine control via the DB15
CONTROL
PORT IN/OUT
connector.
2. A nine pin female
RS-232
serial connection for local and remote control of equipment at either
end of the link.