198
Genie Distribution WNET Manual v3
© Tieline Research Pty. Ltd. 2020
20.13
Configure 2 Mono Peer-to-Peer Answering Connections
Configure a
2 x Peer-to-Peer
or
3 x Peer-to-Peer
answering program to ensure two or three
incoming mono peer-to-peer audio stream connections are always routed to the same outputs.
Routing 2 or 3 Incoming Mono Peer-to-Peer Connections to Specific Codec
Outputs
Important Notes:
Before you start program configuration please note:
·
You cannot edit a program when it is currently loaded in the codec.
·
or multistream program in a codec to ensure it
cannot be unloaded by a codec dialing in with a different type of program. For
example, if a multistream program is not locked it will be unloaded by a mono or
stereo call.
·
Some drop-down menus and settings may be greyed out intentionally depending on
features available and the transport selected (e.g. IP or ISDN).
·
It is possible to save a program at several points throughout the program wizard and
use default settings to save configuration time.
·
Failover is not available with SIP and SmartStream PLUS redundant streaming is
not available with SIP or sessionless IP.
·
To learn more about programs see the section titled
1. Open the HTML5 Toolbox Web-GUI and click
Connect
in the
Menu Bar
, then select
Program
Manager
to launch the
Program Manager panel
.
2. Click the
New Program
button to open the wizard and:
·
Click in the text box to name the new program.
·
Click the
Mix
drop-down arrow to associate a custom matrix mix with the program if required.
·
Select
2 x Mono Peer-to-Peer
, or
3 x Mono Peer-to-Peer
, or if you want to use an existing
program as a template, select this option. Then click
Next
.
3. To configure new program level rules click the drop-down arrow and select the preferred option
from those available. Click the blue
Plus symbol
to add a new rule and click the
Minus
symbol
to remove a rule.