ThermoFisher Scientific EZx, User Manual

Page: 16 / 242

Contents
ii Contents Thermo Fisher Scientific
REC 4132 Rev E
Figure 3–27. Display Alarms Panel ........................................ 3-29
Figure 3–28. User Configurable Alarms.................................. 3-30
Figure 4–1. Filter Regulator Assembly..................................... 4-6
Figure 4–2. Filter Regulator Assembly with Air Filters .............. 4-6
Figure 4–3. Safety Circuit Problem........................................... 4-9
Figure 4–4. Safety Circuit Errors .............................................. 4-9
Figure 4–5. Diode Calibration ................................................. 4-11
Figure 4–6. Start Diode Calibration ....................................... 4-12
Figure 4–7. Performing Diode Calibration............................... 4-12
Figure 4–8. Annunciation Lamp.............................................. 4-14
Figure 4–9. Filter Regulator Assembly.................................... 4-15
Figure 4–10. Air Filter ............................................................. 4-16
Figure 4–11. Touch Screen Calibration Screen .................. 4-17
Figure 4–12. Fuse F1, F2, F3 ................................................. 4-22
Figure 4–13. Fuse F4 ............................................................. 4-22
Figure 4–14. Test Menu.......................................................... 4-23
Figure 4–15. Input/Output Board with LED’s .......................... 4-24
Figure 4–16. Input Diagnostics ............................................... 4-25
Figure 4–17. Output Diagnostics ............................................ 4-26
Figure 4–18. Diode Array Diagnostics .................................... 4-27
Figure 4–19. Diode Array Data ............................................... 4-27
Figure 4–20. X-ray Diagnostics .............................................. 4-29
Figure 4–21. Motor Speed Test .............................................. 4-30
Figure 5–1. Idler Roller ............................................................. 5-5
Figure 5–2. Loosen Thumb Screws.......................................... 5-6
Figure 5–3. Remove the Belt .................................................... 5-6
Figure 5–4. Motor Mounting Screws......................................... 5-7
Figure 5–5. Bearing Retainer Latch.......................................... 5-7
Figure 5–6. Removing Driver Roller Assembly ......................... 5-8
Figure 5–7. Lift up on the slider bed ......................................... 5-8
Figure 5–8. Push slider bed forward......................................... 5-9
Figure 5–9. Remove the first half of the slider bed ................. 5-10
Figure 5–10. Lift up on other end of slider bed ....................... 5-10
Figure 5–11. Back side of the slider bed................................. 5-11
Figure 5–12. Slider bed tail end reinstallation......................... 5-12
Figure 5–13. Push down until slider bed is seated ................. 5-13
Figure 5–14. Place slider bed on top of the first ..................... 5-13
Figure 5–15. Slider bed Installation ........................................ 5-14