Symmetricom SDU-2000, User Manual

Page: 278 / 470

TL1 Command Interface
278 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
RTRV-DATA-GPS-AVAIL:[tid]:
[aid]:ctag;
Valid aid code:
S1A3
or
S1A5
(for a GPS module)
This command returns the current tracking data for the
specified GPS input. If the input specified is not a GPS
module, a DENY response is returned.
The format for the valid response message is as many as 12
lines in the format:
^^^"aid:prn,health,azimuth,elevation”<cr lf>
where:
Each line displays information for one of the satellites
currently being tracked;
prn
= satellite vehicle number
health
= current health of the satellite: H (healthy) or U
(unhealthy)
azimuth
and
elevation
= calculated orientation of the
satellite
RTRV-DATA-FREQ:[tid]:[aid]:
ctag;
Valid aid code: ALL,
S1Ay[-z]
This command returns the current frequency measurements
for the specified input(s).
The format of the response message is:
^^^"aid:freqa,freqb”<cr lf>
where:
freqa
= frequency of the port versus clock A
freqb
= frequency of the port versus clock B
RTRV-DATA-INPUT:[tid]:[aid]:
ctag;
Valid aid code:
ALL
,
S1Ay[-z
]
This command returns the current LOS, AIS, OOF, BPV,
CRC Error and Clear counts for the specified inputs.
The format of the response message is:
^^^"aid:loserr,losclr,aiserr,aisclr,ooferr,
oofclr,bpverr,bpvclr,crcerr,crcclr”<cr lf>
where:
???err
and
???clr
are the erred second count and
cleared second counts for each of the signal faults as
listed above.
Table B-5. TL1 Retrieve Commands (Continued)
Command Description