Symmetricom SDU-2000, User Manual

Page: 93 / 470

12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 93
Provisioning and Operating the SSU-2000
Initial Provisioning
1. Connect a computer to the SSU-2000 using the procedure in Establishing a
Connection With the SSU-2000 , on page 88. The
SSU-2000>
prompt appears.
2. Log in to the SSU-2000:
ICS command:
Type
login
followed by the administrator’s user name and press Enter . The
system prompts for a password. Type the administrator’s password and press
Enter . The system prompt
SSU-2000>
appears.
TL1 command:
Type
ACT-USER::uid:123::pwd;
where
uid
and
pwd
are the administrator’s user id and password, respectively;
123 is an arbitrary ctag value.
3. Provision the reference selection mode. Priority is the default reference selection
mode, and the most widely used mode. See Selecting the Input , on page 30, for
information on selecting the appropriate mode.
ICS command:
Type
REF MODE PRI
then press Enter .
TL1 command:
Type
SET-INPUT-REF:::123::port,PRI;
where 123 is an arbitrary ctag value and port is the selected input port in the
format S1Ax[-z], where x is the slot number (3–12) and z is the channel number
(1–3).
Repeat this command for all inputs.
4. Provision the clocks to enable auto-return (revertive) mode. Symmetricom
generally recommends that auto-return be set to On, unless both clocks are of
the same Stratum level. See
Setting the Reference Switching Mode , on page 31,
for more information on revertive and non-revertive modes.
ICS command:
Type
CLK AR ON
then press Enter .
TL1 command:
SET-CLK-AR:::123::ON;
5. Provision the IP, Gateway, and Subnet addresses for the SSU-2000. The IT
department or site administrator for your location can recommend specific
addresses for these parameters. Use the format xxx.xxx.xxx.xxx for the address.
ICS commands:
Type
IP ADDR [ip address]
then press Enter .
Type
IP GATEWAY [gate address]
then press Enter .
Type
IP SUBNET [subnet address]
then press Enter .