Symmetricom SDU-2000, User Manual

Page: 294 / 470

TL1 Command Interface
294 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
RTRV-PRMTR-GPS:[tid]:[aid]:
ctag;
Valid aid code: S1A3 or
S1A5
(must be a GPS module)
This command returns the settings for the GPS module
designated by the aid.
The format for each response message line is:
^^^"aid:pri,pql,sigma" <cr lf>
where:
pri
= priority setting of [0 through 10, with 0 = MON]
pql
= priority quality level [1 – 16]
sigma
= limit of the noise measurement [10 – 1000 ms]
RTRV-PRMTR-INPUT:[tid]:[aid]:
ctag;
Valid aid code:
ALL
,
S1Ay[-z]
This command returns the settings for the input designated
by the aid. This reports the input module settings.
The format for the response message is:
^^^"aid:pstate,pri,pql,mode,ssm,zs,crc,gain,
csflt,bit" <cr lf>
where:
aid
= port aid
pstate
= port enabled state [ON|OFF]
pri
= priority 1 (highest) through 10 (lowest) or MON for
monitor
pql
= provisioned priority quality level of 1 through 16
mode
= framing type or clock frequency in MHz:
[ESF|D4|CCS|CAS|1|1.544|2.048|5|10]
ssm
,
zs
,
crc
, and
gain
= [ON|OFF]
csflt
= [HI|LO|OFF|NA]
bit
= bit number 4 through 8 of the Time Slot 0 word
used for the E1 sync status message
RTRV-PRMTR-IP:[tid]::ctag;
Valid aid code: None
This command returns the current Internet Protocol settings
for the unit.
The format of the response message is:
^^^"aaa.aaa.aaa.aaa,mmm.mmm.mmm.mmm,
ggg.ggg.ggg.ggg"<cr lf>
where:
aaa.aaa.aaa.aaa
= IP address of unit
mmm.mmm.mmm.mmm
= IP mask of unit
ggg.ggg.ggg.ggg
= IP gateway of unit
Table B-5. TL1 Retrieve Commands (Continued)
Command Description