The level of the first spike is low. Do you wish to use it as a timing spike?
This typically means that no actual timing spike was detected. Verify that the first spike is within one second of the start of the recorded
file. If the recording is noisy and the spike is not very pronounced, you can aid detection by muting the audio immediately before and
after the spike.
An error occurred reading the test tone file
Either the test tone file was not found or is not a valid test tone file. Always use a test tone file provided on the Sound Forge application
disc.
The selected Recorded file is much smaller than the test tone size
This may indicate that the test tone or the recorded file specified in the
Recover
tab is not correct. Verify that the length of the recorded
file roughly the same size as the test tone file.
The end spike was not found
Verify that the spike following the test tone is present in the recorded file when recovering impulses in
Auto-detect timing spikes
mode.
226
|
CHAPTER 13
Summary of Contents for Pro 10
