6-57
DVW-250/250P
6-15. Capstan Motor Replacement
Installation
4. Capstan motor installation
(1) Pass a new capstan motor through the hole of
the chassis in the direction shown in the
figure and tighten it with the three screws.
n
When passing through the hole, be careful
not to scratch the capstan motor shaft.
(2) Connect the connector passing through the
hole of the insulating plate to the capstan
motor board.
n
Do not forget to connect connector.
5. Closing the back side of chassis.
(1) Insert the center hole of the insulating plate to
the boss of the chassis, and fix it using the
rubber ring.
• Check that each lever and pin are put into
each hole of the insulating plate.
(2) Attach the DPR-62 and SST-3 boards. (Refer
to Section 8-2-4 and 8-3.)
6. Cleaning
Clean the capstan motor shaft using a cleaning
piece moistened with cleaning fluid.
Adjustment after replacement
7. Servo system adjustment
(Refer to Section 9-3.)
