Siemens SITRANS FUH1010PVX, Operating Instructions Manual, Page: 93 / 226

2-27
1010BXFM-3
Section 2
Transducer Model 1011 Universal
Transducer Size B3
Xdcr Mount Mode Direct
Spacing Offset Minimum
Number Index 4
Spacing Method Track 1012TP
Ltn Value (in) 0.217
Install Complete? Yes
Empty Pipe Set Channel Not Setup
Zero Flow Adjust Channel Not Setup
Controlotron 2 Channel [1] SITE1
Key [Install] after mounting transducers
Pick/Install Xdcr
To complete the Install process disregard the following paragraphs explaining the
Force Transmit and Force Frequency diagnostic software routines. Proceed to the
Install process completion steps immediately following the Force Transmit procedures.
NOTE: If the transducers have been installed successfully but the Estimated Vs (sonic
velocity) has been changed, the Pick/Install Xdcr menu cell [Install Complete?]
option list will also display the [Transfer Install] function selection. The Trans-
fer Install function allows the transducers to be optimally positioned for a dif-
ferent fluid, without the need for a new Initial Makeup procedure (see the
Water Calibration addendum in this manual for details).
Force Transmit Procedure
This diagnostic software routine allows the user to “force” a transmitting condition that can
be use to search for an amplitude level (ALC) when Detection Fault or Low Signal alarms are
present. The routine forces the flowmeter to generate constant transmit bursts while report-
ing current receive signal strength for the user. To initiate the Force Transmit function, refer
to the example that follows:
1. On a PC, after the detection mode is selected, press <ENT>. If using the Magnetic Wand,
the detection mode is selected, touch <ENTER> sensor. While the flowmeter is going through
the drives (see menu screen below), press the <ALT> and <ENTER> keys simultaneously.
Transducer Model 1011 Universal
Transducer Size B3
Xdcr Mount Mode Direct
Spacing Offset Minimum
Number Index 4
Spacing Method Track 1012TP
Ltn Value (in) 0.217
Install Complete? Install
Empty Pipe Set Channel Not Setup
Zero Flow Adjust Channel Not Setup
Controlotron 2 Channel [1] SITE1
Drive 0
Pick/Install Xdcr
Transducer Model 1011 Universal
Transducer Size B3
Xdcr Mount Mode Direct
Spacing Offset Minimum
Number Index 4
Spacing Method Track 1012TP
Ltn Value (in) 0.217
Install Complete? No
Empty Pipe Set Channel Not Setup
Zero Flow Adjust Channel Not Setup
Controlotron 2 Channel [1] SITE1
Key [Install] after mounting transducers
Pick/Install Xdcr
Siemens Hardware