Siemens SITRANS FUH1010PVX, Operating Instructions Manual, Page: 171 / 226

4-15
1010BXFM-3 Section 4
To assign a Network ID number
To enable numeric entry press .
Use PC numeric keys or Magnetic Wand to enter the Network ID number.
To store Network ID press . This moves the cursor to [RTS Key Time].
4.8.6 RTS KEY TIME
During a serial transmission session, you can select how long the computer holds its request-
to-send line high while checking for a clear-to-send signal. If RTS key time expires, the 1010
will return its RTS line low and abort the transmission attempt. Data entry units are seconds.
The default RTS key time is 0.2 seconds.
NOTE: The RTS Key Time function is only provided when the meter’s Network ID
number is non-zero.
To set the RTS Key Time:
To access the [RTS Key Time] option list press .
To move the asterisk to the required RTS time by pressing
To store the data press .
4.9 SYSTEM INFO
This menu provides general information about the 1010BX meter.
ENT
ENT
Version This is the meter’s operating system version number. Controlotron’s Technical
Services Group may request this number during consultations.
Reset Date/Time Shows the date and time of this meter’s last active or dynamic memory reset.
Op System P/N Meter’s operating system part number.
Checksum Operating System verifying code. Controlotron’s Technical Services Group may
request this number during a consultation.
Code Software Compile Date/Time. Operating System identifier. Controlotron’s
Technical Services Group may request this number during a consultation.
System Info Menu Structure
4.10 DATA DISPLAY SCREEN
The alphanumeric display of the 1010BX provides visual access to all system variables and
conditions. During installation the 2 x 16 character alphanumeric display is only used to ac-
cess the numerous menus offered by the 1010BX system. Once a measurement channel is
activated and begins operation it can display a wide variety of meter data.
4.10.1 ACTIVATING THE DISPLAY
To activate the Display Screen, simply connect power to the 1010BX system. On power-up the
1010BX will display one of the following:
z
The scrolling Controlotron Welcome Screen (i.e., if no channel had been previously acti-
vated), or
Siemens Hardware