Siemens SITRANS FUH1010PVX, Operating Instructions Manual, Page: 51 / 226

1-23
1010BXFM-3 Section 1
1.13 NAVIGATING THROUGH THE INSTALLATION MENU
After successfully accessing the Installation Menu, you can begin to set up the 1010BX. The
following table shows the PC keyboard Installation Menu navigation keys.
1.14 USING THE 1010BX RESET SEQUENCE
Should you encounter an operating problem that blocks access to the System Menu, or the
meter operates erratically after exposure to a power transient or some other traumatic event,
this might require the use of the reset sequence in order to restore proper operation. System
1010BX provides two system resets. The first uses the magnetic wand and the second method
uses a PC command sent via the RS-232 interface (providing you have access to the flow com-
puter in this way). This section describes both system reset methods.
The reset sequence operates on two levels. The first level deletes all the data currently in
Active Memory, but leaves Datalogger data and all stored Site Setups intact. This is the most
desirable method since to restore operation all you have to do is reload a saved Site Setup. If
this fails then you have to use the second level, which clears ALL Dynamic Memory. Be aware
that this action erases all saved Site Setups ( including flow calibrated sites ), any logged
data and any user-defined pipe and transducer tables. This will require you to re-initialize the
meter and transducers and repeat all desired site settings, custom pipe tables, etc.
PC KEYBOARD DESCRIPTION
MENU Enter Installation Menu.
<UP Arrow> Move up one menu cell (or change Flow Display screen).
<DOWN Arrow> Move up one menu cell (or change Flow Display screen).
<RIGHT Arrow> Move right one menu cell.
<RIGHT Arrow> (during Install) Allows manual frequency selection.
<LEFT Arrow> Move left one menu cell. Repeated <LEFT Arrow> exits
Menu and Display screen.
^L (Ctrl L) Exits Menu.
<ENT> Enter data and re-enter menu from Flow Display screen.
<Enter> (during Install) Forced Transmit test mode (Version 3 software)
<Backspace> or <DEL> Deselect list selection or zero numeric entry.
| (bar) Shift + \ (back slash) Change number sign or type (-) minus key.
Digits Numerals zero through 9.
Decimal Point.
@ System Reset (refer to paragraph 1.14).
Siemens Hardware