Siemens SITRANS FUH1010PVX, Operating Instructions Manual, Page: 33 / 226

1-5
1010BXFM-3 Section 1
This must be
connected to Earth
Ground.
Fuse (F1) GMA 2A
Cable Clamp
Loosen Wire Clamp
Screw, insert stripped
end of wire and then
re-tighten.
Strip wire insulation
back by 0.031” (8mm).
1.7 POWER CONNECTIONS
1.7.1 INPUT POWER CONNECTOR (P8) AND FUSE (F1) LOCATIONS
The 1010BX Interface Detector requires 100/120/200 VAC or 9-36 VDC for its power input.
The power input is protected by a GMA 2A fuse (F1). Please replace this fuse with the exact
type if it becomes necessary to do so.
1.7.2 POWER SUPPLY WIRING
NOTE: Refer to installation drawings 1010BX-7 (1 of 3) and 1010BDX-7 (1 of 3).
WARNING: Turn off main power before installing AC connections to the 1010 NEMA
flowmeter. Contact with exposed wiring may lead to fire, electric shock,
or serious personal injury.
z
Using a 1/16" Hex key, loosen the 1010X Rear Housing Cover locking setscrew.
z
Unscrew the Rear Housing Cover and remove.
z
Locate power supply connector J8.
z
Pull wires through flowmeter case conduit cable hole.
z
Wire input power connector P8 for AC or DC power as shown below. Insert wires into
wire entry holes and secure by tightening wire clamp screws.
NOTE: Power Supply connector wires should be stripped stranded or solid conductors
AWG 12 -18.
Siemens Hardware