Rostock MAX v2 Assembly Guide – 4thEd.
Using a pair of needle nosed pliers, bend the resistor leads as shown in the following photos.
The resistor leads on the hot end are too long to used right
now. In order to trim them to the proper length, place one of
the crimp connectors along side the wires and mark the wires
just behind the center point of the crimp as shown below. Trim
the leads off at that mark.
Finally, attach the crimp on connector to the freshly
trimmed leads as shown.
Repeat the process for the leads on the other side of
the heater block.
11 – Installing the Hot End and Bowden Tube – 101
Fig. 11.3-1: Step #1.
Fig. 11.3-2: Step #2.
Fig. 11.3-3: Step #3.
Fig. 11.3-5: Marking the trim point.
Fig. 11.3-4: Leads marked for cutting.
Fig. 11.3-6: Leads trimmed.
Fig. 11.3-7: Crimp installed.
Fig. 11.3-8: Ready for wires.