Miniature Display
R&S
®
FPS
40
Getting Started 1319.3362.02 ─ 07
The subnet mask consists of four number blocks separated by dots. Each block
contains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two
numbers are allowed in a block (as an example see the preinstalled address).
System commands
Provides basic system functions.
Preset ← System commands
When delivered, the R&S
FPS has a default configuration. You can restore this
defined initial state at any time as a known starting point for measurements. This
is often recommendable as a first step in troubleshooting when unusual measure-
ment results arise.
Remote command:
*RST
or
SYSTem:PRESet
Self align ← System commands
Starts recording correction data for the instrument. If the correction data acquisi-
tion fails or if the correction values are deactivated, a corresponding message is
displayed in the status field.
Selftest ← System commands
If the R&S
FPS fails you can perform a self test of the instrument to identify any
defective modules.
Once the self test is started, all modules are checked consecutively and the test
result is displayed.
LAN Reset ← System commands
Resets the LAN configuration to its default settings (LCI function).
According to the LXI standard, an LCI must set the following parameters to a
default state.
Parameter
Value
TCP/IP Mode
DHCP + Auto IP Address
Dynamic DNS
Enabled
ICMP Ping
Enabled
Password for LAN configuration
LxiWebIfc
Clear All Messages ← System commands
Deletes all system messages.
Functions and Settings in the Mini Display Menu
Summary of Contents for R&S FPS
Page 25: ......
