Preparing for Use
R&S
®
FPS
15
Getting Started 1319.3362.02 ─ 07
2.1.4
Connecting the AC Power
In the standard version, the R&S
FPS is equipped with an AC power supply con-
nector. The R&S
FPS can be used with different AC power voltages and adapts
itself automatically to it. Refer to the datasheet for the requirements of voltage
and frequency. The AC power connector is located on the rear panel of the instru-
ment.
For details on the connector refer to
Chapter 3.2.10, "AC Power Supply Connec-
► Connect the R&S
FPS to the AC power supply using the supplied power
cable.
Since the instrument is assembled in line with the specifications for safety
class EN61010, it may only be connected to an outlet that has a ground con-
tact.
2.1.5
Switching the Instrument On and Off
Switching the instrument on
► Press the AC power switch on the rear panel to position "I".
The instrument is supplied with AC power. After booting, the instrument is
ready for operation. A green LED above the POWER key indicates this.
Warm-up time for OCXO
When the instrument is switched on, the OCXO requires an extended
warm-up time (see data sheet). No warm-up time is required when starting
from standby mode.
Switching the instrument off
1. Press the POWER key on the front panel of the R&S
FPS.
Putting into Operation
Summary of Contents for R&S FPS
Page 25: ......
