9
DMAC
9-33
32180 Group User’s Manual (Rev.1.0)
DMA transfer starts as requested by
internal peripheral I/O
DMA transfer
processing starts
Transfer count register underflows
Interrupt request generated
Set DMA0 Channel Control Register 0
Set DMA0-4 Interrupt Request Status Registers 0 and 1
Set DMA0 Channel Control Registers 0 and 1
Set DMA0 Source Address Register
Set DMA0 Destination Address Register
Set DMA0 Count Register
Setting
DMAC-related
registers
Starting DMA transfer
DMA transfer
completed
• Transfers disabled
• Interrupt request status
bits cleared
Set DMA0-4 Interrupt Request Mask Register
• Source address of transfer
• Destination address of transfer
• Number of times DMA transfer
is performed
• Transfer mode, request source,
transfer size, address direction
and transfer enable
DMA operation
completed
• Interrupt request enabled
Set the interrupt controller's
DMA0-4 Interrupt Control Register
• Interrupt priority level
Setting interrupt
controller-related
registers
Figure 9.3.1 Example of a DMA Transfer Processing Procedure
9.3.2 DMA Transfer Processing Procedure
Shown below is an example of how to control DMA transfer in cases when performing transfer on DMA channel 0.
9.3 Functional Description of the DMAC
Summary of Contents for M32R/ECU Series
