Raritan PMC-1000, User Manual

Page: 422 / 621

Chapter 5: Using the Command Line Interface
410
Determining the SSH Authentication Method
This command syntax determines the SSH authentication method.
config:# network services ssh authentication <auth_method>
Variables:
•
<option> is one of the options: passwordOnly, publicKeyOnly or
passwordOrPublicKey.
Option Description
passwordOnly Enables the password-based login only.
publicKeyOnly Enables the public key-based login only.
passwordOrPublicKey Enables both the password- and public
key-based login. This is the default.
If the public key authentication is selected, you must enter a valid SSH
public key for each user profile to log in over the SSH connection. See
Specifying the SSH Public Key (on page 448).
Setting the SNMP Configuration
You can enable or disable the SNMP v1/v2c or v3 agent, configure the
read and write community strings, or set the MIB-II parameters, such as
sysContact, using the CLI commands.
An SNMP command begins with
network services snmp.
Enabling or Disabling SNMP v1/v2c
This command enables or disables the SNMP v1/v2c protocol.
config:# network services snmp v1/v2c <option>
Variables:
•
<option> is one of the options: enable or disable.
Option Description
enable The SNMP v1/v2c protocol is enabled.
disable The SNMP v1/v2c protocol is disabled.