Raritan PMC-1000, User Manual

Page: 400 / 621

Chapter 5: Using the Command Line Interface
388
Setting the IPv4 Address
After selecting the static IP configuration mode, you can use this
command to assign a permanent IP address to the BCM2 device.
config:# network ipv4 interface <ETH> address <ip address>
Variables:
• <ETH> is one of the network interfaces:
ethernet, wireless, or bridge.
Note that you must choose/configure the bridge interface if your
BCM2 is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET and
WIRELESS interfaces do NOT function.
Interface Description
ethernet
(BCM2)
Determine the IPv4 address of the ETHERNET
interface (that is, wired networking).
eth1
(BCM2-iX7) Determine the IPv4 address of the ETH1 interface
(that is, wired networking).
eth2
(BCM2-iX7) Determine the IPv4 address of the ETH2 interface
(that is, wired networking).
wireless Determine the IPv4 address of the WIRELESS
interface (that is, wireless networking).
bridge Determine the IPv4 address of the BRIDGE
interface (that is, the bridging mode).
• <ip address> is the IP address being assigned to your BCM2 device.
Its format is "IP address/prefix". For example,
192.168.84.99/24.
Setting the IPv4 Gateway
After selecting the static IP configuration mode, you can use this
command to specify the gateway.
config:# network ipv4 gateway <ip address>
Variables:
• <ip address> is the IP address of the gateway. The value ranges from
0.0.0.0 to 255.255.255.255.