3152B User Manual
Publication No. 980935 Rev. A
The Operation panels are detailed in the next section.
Output
ArbConnection displays the Output panel, shown in Figure 4-5,
automatically. The buttons and LEDs are arranged in the following
groups:
•
General Parameters. These controls adjust amplitude and
offset.
•
Wave Mode. This group lets you select the waveform mode.
•
Run Mode. These controls are for selecting the Continuous
mode or one of the interrupted modes (Trigger, Gated, or
Burst).
•
PLL. These controls enable and disable phase locking, and
select the source signal.
•
Sync Output. This group enables and disables the sync
signals on the VXIbus backplane and front panel, selects the
sync qualifier, and allows you to adjust the sync pulse
position and width relative to the waveform.
•
Output. These controls are for turning the output signal on
and off, and for selecting the load impedance.
Pushbuttons
Radio
Buttons
LEDs
Dial
Digital Display
Figure 4-5, Output Panel
When you click on a button, the 3152B responds immediately.
When you change a numeric parameter on the display, the 3152B
does not respond until you click on the Modify/Execute knob to
update the instrument.
Some controls in this panel also appear in other panels. When you
change a parameter in this panel, the other panels are updated
4-6 ArbConnection
EADS North America Test and Services
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com