Quantum Scalar i40, User Manual

Page: 244 / 328

Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
218 Quantum Scalar i40 and Scalar i80 User’s Guide
2 Place the replacement magazine next to the removed magazine in
the same orientation. Make sure they look the same from all angles.
• The storage slots face inward.
• On the outer wall of the magazine, the silver rollers sit below
the springs (see Figure 54 ).
Figure 54 Proper Orientation
(Right-Side Magazine)
Springs
Silver rollers
3 Choose the correct bezel (left or right) from the magazine
replacement kit.
Note: If you try to install the wrong bezel, it will not fit and you
will not be able to install it.
4 Push up on the top bezel tabs and fit them over the posts on the
top of the magazine. Turn the magazine over and repeat on the
bottom (see
Figure 55 on page 219).
5 Install the two washers and two M3 screws securing the top of the
bezel to the magazine. Install them in the outer hole in each tab
(see
Figure 55 on page 219).