![background image](http://html2.mh-extra.com/html/quantum/scalar-i40/scalar-i40_user-manual_3962593255.webp)
Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing the System Control Board
Quantum Scalar i40 and Scalar i80 User’s Guide
229
5
Check the library’s date, time, and time zone settings and
reconfigure if necessary. From the Web client, select
Setup > Date
& Time
.
6
If you changed the IP address from what it was originally, update
host and other applications that access the library.
7
Save the library configuration. From the Web client, select
Tools >
Save/Restore Configuration
. Select
Save Configuration
and click
Apply
. Save the configuration to a known location.
8
It is recommended that you run the Installation and Verification Test
(IVT). From the operator panel, select
Tools > IVT
and follow the
instructions. The IVT takes about 30 minutes. If any problems are
detected, the library issues a diagnostic ticket.
9
Package the old SCB in the packaging that shipped with the new
SCB and send the old SCB back to Quantum.
Manually Reconfiguring
the Library
Follow the instructions in this section if you do not have a saved library
configuration.
1
If you had licenses installed on your library, have the license keys
handy so you can install them on the library. If you no longer have
them, you can obtain them at
http://www.quantum.com/
licensekeys
, or from Quantum Support.
2
When the firmware update is complete, the Setup Wizard appears
on the operator panel screen. The Setup Wizard helps you configure
the date, time, IP address, IPv6 enable/disable, licenses, partitions, I/
E slots, and cleaning slots.
3
Complete the Setup Wizard on the operator panel. If you make a
mistake or do not complete all the screens, you can change the
configuration later using the operator panel or Web client
Setup
menus.
Note:
You cannot update the library name or time zone on the
operator panel. If the displayed library name or time zone
is incorrect, change it later using the Web client (see
Step 8
on page 230).
4
Take note of the library’s IP address (on the operator panel, select
Reports > Network Settings
).
Summary of Contents for Scalar i40
