Quantum Scalar i40, User Manual

Page: 45 / 328

Chapter 2: Initial Installation and Setup
Connecting the Cables
Quantum Scalar i40 and Scalar i80 User’s Guide 19
Connecting the Cables
Follow the instructions for connecting the cables in Connecting Library
Cables on page 173.
Turning the Library ON and Configuring Network
Settings
Caution: Before turning the library on, make sure you removed the
shipping restraint (4 thumbscrews, mylar sheet, metal clip)
from the top of the library! Otherwise, the library will not
initialize. See Figure 8 on page 17.
1 Turn the library ON by pressing the power button on the front bezel
(see Figure 9 ).
• The green power LED on the front panel above the power
button illuminates, and the LCD screen turns on. The library
goes through a connection and initialization sequence. This can
take 5 to 17 minutes, depending on the size of your library.
• The status LED on the rear of each drive sled turns green during
initialization.